Search
Products

Fluidfit elbow hand valve female thread BSPP – HESV – Tierre

The Tierre HESV Fluidfit elbow hand valve female thread BSPP has a POM acetal resin body and EPDM seals and works up to 10 bar at 65 °C in continuous use (10 bar at 90 °C for 5 minutes max), with BSPP 1/2″ thread. Available for 3/8″ inch tube.

Available product codes: HESV3/8-G04G.

Download

Catalogs and technical documentation

Fluidfit elbow hand valve female thread BSPP – HESV – Tierre

Description

Features and application

The Tierre HESV Fluidfit elbow hand valve female thread BSPP is a 2 ways elbow hand valve for inch tube, with a push-in connection and a BSPP female thread; the detailed technical datasheet is available on request.

Fluidfit products are designed for water, food and air contact but can also be used with selected gases, vacuum and other liquids; easy actions allow the tube to be connected and released quickly, saving time and expenses.

It is part of the Tierre Fluidfit fittings range, together with the Fluidfit 2 ways hand valve male thread BSPT HBVL-R and the Fluidfit 3 ways hand valve BSPP 1/2″ with diverting connection for 1/4″ tube HAAV.

Materials

  • Case, covers, cap, ring and shaft: POM acetal resin
  • O-ring, shaft o-ring and seal: EPDM
  • Gripping collet: POM and AISI 301 stainless steel

Technical data

Feature Value / Specification
Maximum temperature 65 °C for continuous use; 90 °C for short-term use (5 minutes max)
Maximum working pressure 10 bar at 65 °C for continuous use (10 bar at 90 °C for short-term use, 5 minutes max)
Thread BSPP 1/2″ thread
Tube (ØD) 3/8″ inch tube

Connecting and disconnecting the tube

Make sure the tube and the push-in system are the same size and cut the tube square with a proper tube cutter, such as the ETC tube cutter; the tube must be clean, without scratches, cuts or deformities. Insert it by hand up to the end stop, without tools, and pull it once without releasing the collet to check it is connected; then fit the locking clip between body and collet and push the tube in again.

To disconnect, completely eliminate the pressure from the system, remove the clip, push the collet towards the fitting body and pull the tube keeping the collet pushed. When using metallic tubing, always deburr the tube ends to avoid damaging the o-rings.

Product codes

Code ØD T (BSPP) ØP A B L1 L2 L3 Weight (g) Pcs/pack
HESV3/8-G04G 3/8 G 1/2 38.7 18.0 20.2 65.75 53.15 61.7 35.3 20

Dimensions refer to the technical drawing in the downloadable PDF data sheet; inch version dimensions are given as in the catalogue.

Technical data from the catalogue Tierre Fluidfit, fittings for potable water, drink dispensers and beverages, Rev. 3.0.

Brands

List of Manufacturers Brands

TIERREGROUP

RUOTA IL DISPOSITIVO PER VISUALIZZARE CORRETTAMENTE IL SITO