HNP076 Series Oil Purifier

Description

HNP076 Series Oil Purifier

Water contamination promotes corrosion and fluid system component wear, resulting in reduced component life and increased maintenance costs.

It also degrades fluid properties, leading to reduced lubricity and load carrying ability, oil oxidation and the resultant formation of acids, and additive precipitation. The consequences are reduced fluid service life, increased fluid procurement and disposal costs.

The Pall HNP076 Series Oil purifier is designed for use with medium to large oil systems, particularly where high viscosity fluids are employed, and can effectively remove up to 40 liters of water per day from oil.

The Pall HNP fluid conditioning purifier uses vacuum dehydration to remove 100% free water and as much as 90% of dissolved water. It will also remove 100% of free and entrained gases and up to 80% dissolved gases.

Vacuum dehydration is the most effective method of water removal at minimum cost and ease of use. Unlike other methods it removes both free and dissolved water and cannot burn or otherwise significantly alter the properties of the oil.

Particulate contaminant removal is achieved using high performance rated (ßx(c) >2000) Athalon® filter elements.

In addition, a WS12 Series water sensor measures water content and temperature at the purifier inlet, allowing the purifier to operate only when the water content rises above a pre-determined level.

Select the HNP076 oil purifier for:

• High-performance water, gas, and particulate removal
• Extension of fluid service life
• Minimized corrosion within systems
• Reduced fluid disposal
• Reduced operating costs
• Increased equipment reliability
• Simple automated operation
• Remote monitoring option

Removing free water is never enough!

1. Initial water content is above saturation (free water).
2. Maximum water removal capability of ‘free water removal’ devices (coalescers, centrifuges, etc.) is to the oil’s saturation point.
3. Water content achieved with vacuum dehydration is significantly below the oil’s saturation point.
4. Water content achieved with vacuum dehydration remains below the oil’s saturation point even after oil is cooled by the system heat-exchanger cools the oil. This prevents the formation of free water, which is detrimental to fluid system components and the fluid.
5. If only free water is removed at the initial temperature, when oil is cooled, the amount of free water in the oil can increase significantly.